Suported links   www.clearfuel.co.uk   www.eurotron-products.com   www.alpha-cookers.co.uk   www.analysers-uk.com   www.oilburnerspares.com

Tel . 0121 370 5691   Fax. 01905 723 191 Mob. 07788924623

Analysers UK part of the Clearfuel group

Analysers-UK 53 Tunnel Hill, Worcester. WR4 9SD

All prices are subject to VAT and Delivery

New Phone Number

Tel. 0121 370 5691

Card payments can be taken by phone

Analysers-UK is a Service Calibration and Repair centre for

Eurotron Instruments UK Limited

Proprietary design trap

To inhibit water into the instrument

External, to prevent risk of instrument

Damage.

Big water tank capacity for condensation boilers. Small rubber cup to easy remove unwanted water from thw traps tank.

A long life paper filter that is easy removed and replaced.

Magnetic Rubber holster included

The Unigas 1000 comes with a Magnetic Holder. That will help keep the analyser in up right position.

The Unigas 1000+ complies with the BS EN 50379 part 1 and 3 which outline the performance used in non-statuary application.

Additional task such as CO room build upto comply with the BS7967,

Tightness test in accordance with IGE/UP/1B

UniGas 1000 - Low cost tool for boiler maintenance

Down Load Date Sheet

UniGas 1000 is a 2 sensors compact flue gas analyser. Two internal electrochemical sensors read the Oxygen (O2) and carbonic monoxide (CO) gas concentration. The gas temperature and air temperature are used in connection with the gas analysis to calculate the efficiency, excess air, and CO2 concentration. A 10 gas parameters programmable table is used for calculations approved in accordance with DIN33962.

Each UniGas 1000 is factory calibrated and certified against Eurotron standard to ensure traceability, and shipped with a Report of Calibration. The instrument is available with or without a built-in rugged impact printer. It uses a low cost common roll paper.

The UniGas 1000 features the Differential pressure/draft input, (0.01mbar resolution.)

Smoke Index on printer out

Ambient CO safety Monitoringwith separate printer out with test results (complies with BS7967)

Temperate flow differential flow and return with printer out.

Efficiency Net/Gross and condensing reading.

Ni-MH rechargeable batter provide long field use. Unigas 1000 is powered by a unique batteries that    also powers the printer and the flue gas analyser at the time. No need to have two set of battery the Unigas only need one.

The instrument has a CO resolution of 1 ppm and it uses a proprietary designed water trap. His Ni-MH rechargeable batteries provide longer field use. Flue gas analyser and itnernal printer are powered by unique batteries. The battery charger is supplied.

UniGas 1000 comes with the Magnetic Rubber Holster included!

Download

Brochure Unigas 1000
Basic combustion analyser.

Download file

Instruction Manual MM850482 ed.04
This manual is valid for instruments with serial number 71707 and firmware rev. 1.002 or higher.

Download file

CO/CO2

ratio

O2

CO

CO

2

Efficiency

Tair

Tgas

Differential

pressure

Excess air

Large LCD

Show three lines of parameters.

With alto Back light making it easy to see in low light conditions.

With a optional  external remote temperature sensor for balance flue boiler gives you a more excrete efficiency measurement reading.

CO Room build-up

Will test the CO room build-up over a set time and will report the finding. And produce a print out.

Temperature Flow and Return differential.

Measurements are displayed on the analyser screen. Printout can also be created.

Temperature claps allow this operation to be carried out with great ease.

Tightness test

Menu to perform task in accordance with IGE/UP/1B

Let-by test

Screen shot of let-by test the is in accordance with IGE/UP/1B

Unigas 1000 is complete with a build-in impact printer for long lasting reports.

Customised header

The print out can be customised

CO

CO

2